Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I performed an ISSU upgrade on the Catalyst 9500-40X switches from IOS-XE 17.15.6 to 17.18.4. During the upgrade, I observed traffic interruption and ping drops for approximately 15–20 seconds, despite NSF and SSO being enabled.Is this expected be...
Hi,API call - Get Organization Wireless Radio Rf Health Overview By Network By Interval - Meraki Dashboard API v1 - Cisco Meraki Developer Hubthere is no scope defined for this API call, when I tried testing with Oauth 2.0 the same it throws me sayin...
Hi, I tried running the below API call however in the output i see some weird RSSI values. Can someone confirm me why do i see this '0' values ?API call -https://api.meraki.com/api/v1/organizations/{{orgId}}/wireless/roaming/byNetwork/byInterval?netw...
Hi,Has anyone implemented/studied on how to track bad/good roaming using the Meraki API calls? I cannot find a direct API available for same and also, under assurance --> Analytics --> Overview i see the roaming behavior so do we have any API calls f...
I see above logs and to my understanding in a SVL with single uplink towards SDWAN routers, it is tough to maintain the adjancies/neighborship as the interface itself goes down despite NSF/SSO enabled.
Yep, Pings were transit! Also, the router is Versa so NSF or NSF IETF will work. What is difference between both ? I have scenarios where we run BGP as well.
Basically, I have 9500-40X in Stack & from each stack switch there is only a single uplink going towards the respective primary & secondary SDWAN routers. The SDWAN routers are operating in Active-Active Mode and advertises Default route over OSPF wi...
