Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Dear Community,I am trying to set up a BMP Server in my network. But I am no getting any data from it. So far my target server has a wireshark running to see if there is any data incoming. I don't see any communication at all. The public IP addresses...
Hi.. I am trying to extend a lab on my own. I want to make a multi-area OSPFv2 setup using Cisco 2911 within the PT. The HQ router (lar001) has the following setup:router ospf 1log-adjacency-changesnetwork 10.10.0.0 0.0.0.3 area 0network 10.1.0.0 0....
Hello Harold! You've pointed me into the right direction. I just need to setup the BMP collector now. And you were right. I missmatched the interfaces on the schematic. Regards,Andreas