Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Currently I have 6 remote sites on 1 Cisco ASA 5510. This ASA is my main firewall for all internal users at our main site and remote home workers vpn destination. Users who work from home and VPN into the ASA can access anything on the inside inter...
I am trying to setup an additional Anyconnect vpn profile. I have one that is working correctly but this new one will not. When I try to login to download the client or try to connect with a computer that already has the client I am unabl...
I am currently using AnyConnect as an SSL VPN service for some outside vendors to access a few of our applications. Unfortunately some of them refuse to download software, so I need to setup a clientless solution. I used the SSL VPN wizard and setu...
The group policy we are currently using for anyconnect is assigned to only use sslvpn client as the tunneling protocol. Whenever anyone connects directly from anyconnect it shows them as a clientless session. Any ideas on this? Needing this fast i...
Ok users are able to connect and I have setup a good ldap attribute map. The problem is they are not able to RDP into any of the subnets I have specified. Users in the An1meR0xs tunnel group have full access but I am trying to lock down the AnyConn...
Fantastic. I created a new LDAP authentication and used this. I got it to work without a map attribute. I need to get that working properly as well but this is a great first step.---Kyle
It is browseable. I apologize it was not yesterday but that may have been an error with my outside test network.I attached the config. The working tunnel group is Anyconnect
Both the browser and the anyconnect client give the same client side/asa side error.It does not allow me to currently hit it by 64.244.9.X/VPN_FUNI can browse all my connections from 64.244.9.X
