Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am running a Cisco 2621 router with Enterprise Base 12.3(10c).I am tring to configure the router for the Multiple Tracking Options of PBR.all goes well until I try to enter the "track 123 rtr 1 reachability" command,the router does not have an rtr ...
I am in the process of adding a second ISP for my internet connection, what would be the best approach to load share the outbound data between the two ISPs?
I plan on using a 3750 layer 3 switch as a multileg router for several subnets. When I set a 3750 port toa fixed vlan, and put and 3548 switch with no vlans configured, I get the following error"CDP-4-NATIVE_VLAN_MISMATCH:"My existing switches are a...
If you are NATing the firewall rules are applied before the nat, so it could see the connection as between an internal and another internal address, and deny it. I seem to recall that we needed to have ICMP enabled and several other things for the up...
I run DHCP through my 3750, I needed to put a IP Helper-address in the DHCP vlan description.Example:vlan 5ip address 192.168.1.0 255.255.255.0 (DHCP user vlan)ip helper-address 192.168.5.25 (DHCP servers address)John Bahm
it is my understanding that Gig E will only work properly in auto mode, the only reason to work with the settings is if you want 10 or 100 mbps.John Bahm
Thanks for the reply.Best for me means, most reliable. I am eliminating all of the single points of failure. With the addition of the second ISP I hope to share the bandwidth on the outbound path, and have ether path run the full load in the event of...
I have configured a network for HACMP, all of the involved network ports need to be in the same layer 2vlan. I think the trigger events are the hard part.If your configuration gets complicated, it might help to do a simple state table. Good luck.
