Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am attempting to trunk between a Cisco 4948 Catalyst and a Cisco Linksys (8 port SRW2008 10/100/1000 Gigabit Switch). I have the commands for the 4948 but I am missing something on the Linksys. My Cisco 4948 commands are:#switchport trunk encapsu...
We have a situation that requires one laptop to have access to two our three VLANS. We have a Cisco Catalyst L3 4948. The three VLANS are VLAN10, VLAN20, and VLAN30. The workstation currently is a member of VLAN10 and needs to also have access to ...
We have three VLANS and would like to combine two. We are using "ip pim sparse-dense-mode" on each VLAN to manage multicast traffic. We would like to run two different subnets on one VLAN. We really don't want to readdress all of our devices. Can...
We are attempting to install Cisco Works 3.2 on our Windows 2003 Server. We have an eval version given to us by our Cisco Rep. The installation errors out because it is a PDC. We have no other 2003 Servers to install it on . We do have Solaris 10...
I have a Cisco 4948 Catalyst. We have been asked to configure BPDU globally. So I believe the command is Switch (config)# spanning-tree portfast bpduguard default. After entering the the global command is it possible to disable the command on an i...
OK you've been very helpful! Last question...I hope...Can a port on the Linksys belong to two VLANs thus eliminating the need for Inter-VLAN routing on the 4948. Once again thank you.~c
I only have four machines on the Linksys that need access to the two VLANs on the 4948. I guess what I'm asking is can these 4 machines be a member of one VLAN on the Linksys and gain access to both VLANs on the 4948? Thanks for th quick reply.~c
I have yet to create my VLANs on the Linksys. The linksys is currently running the default VLAN1. Question, if the VLANs I want access on the other switch are VLAN10 and VLAN30, and my trunk connects physically to VLAN10 on the Cisco 4948, do I nee...
The SVIs may be a solution for us. We have no security issues since this is a closed network with priviledged users only. So lets see if I understand this. I configure a secondary ip address on one interface in each VLAN. I then configure the win...
We were wondering if we can directly connect a laptop to a vlan on our 4948 using the trunk commands listed below? We currently have three VLANS on the switch and would like this maintenance laptop have the ability to access all three vlans. The th...
