Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,In the lab instructions there are no details about the login details for the sandbox and I am unable to authenticate on the NCS5K via ssh even though the VPN is up and the SSH connection is established. What username/passwords are we supposed t...
Hello all,I am trying to get an ASA running v7 OS working as an easy vpn server behind NAT in the following scenario:ASA(EZVPN_Server)-----Gateway----Internet-----Gateway-----Router(EZVPN_Client in NEM mode)There is a static nat entry on the gateway ...
Hello all,I've spent the whole day on Friday troubleshooting this issue, but have not figured out what the problem is yet and was hoping you could help me out. I tested the config on different platforms using different IOS so I suspect a configuratio...
Hello,I configured the SSL VPN feature on a 1941 ISR running IOS 15.01M in order to use the AnyConnect client. However, after I open the welcome portal, where you have to type in a username and a password, I get a message "Login failed" before I even...
I have also been experiencing the same issue. I raised a support case ticket a few weeks ago but it's gone nowhere - the two DNAC + ISE sandboxes (not the always-on ones) are still broken. @bigevilbeard Do you know of any way to escalate this interna...
Hi Xander,Another excellent article as always! Thanks a lot.Can you please clarify how policing is applied to priority queue classes? Let's assume we have the config below. Does that mean each class is allowed to send up to 70% of the interface bandw...
Hi Xander,Is it possible to use the PBR feature above to route traffic through an MPLS TE tunnel? I see you can only specify a next hop and not an outbound interface so I presume we couldn't achieve this on IOS XR and we have to use either autoroute ...
TE path protection also not supported on XRv.RP/0/0/CPU0:XR1(config-if)#show conf failedThu Mar 6 22:45:07.297 UTC!! SEMANTIC ERRORS: This configuration was rejected by !! the system due to semantic errors. The individual !! errors with each failed ...
Multicast routing does not seem to work over MPLS P2MP TE tunnels. Although the packets show up as forwarded out the MTE interface, they are not. I ran a packet capture to confirm this. RP/0/0/CPU0:XR1#sh mfib int tunnel-mte5 Sat Mar 1 13:43:4...
