Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello All,
I had a deffered IOS on my stack, so i have installed the new IOS and issued a reboot and the switch stack came back up....
however, the switch which was active is no more active as the highest MAC address is now active..
i wanna mak...
Hi All,
We have a stack of 3 switches which are on the below IOS
Switch Ports Model SW Version SW Image Mode ------ ----- ----- ---------- ---------- ---- * 1 56 WS-C3850-4...
hello team, we have a router in production & i have ordered HSEC and AppX license for the router from our vendor and he has sent me PDF files with PAK's. Can you please let me know how to install these licenses step by step.TIA
If you have 2 ISP's connected to the core, you can use BGP ( with IPSLA tracking )not OSPF, you can use EIGRP (UECLB). or have a static route with higher AD on the core to manipulate the traffic (if one goes down , the other comes up)
Let suppose i'm adding a new stack member Leo ... if i still reboot the stack... i dont think i can accomplish my need.....Please advise further, Thanks
as per Cisco
Booting the switch in Bundle mode consumes more memory than the Install mode because the packages are extracted from the bundle and copied to the RAM.
Thanks Mark
After we do the same .. i hope all the switches will be under INSTALL MODE? ( just curious regarding the BUNDLE MODE issue)
Please advise, Thanks
