Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,I had posted this earlier under the data center section but didnt really get any answers. Figure since the issue is more a L2 bridging issue than ACE specific anyway, I thought I'd ask here. The ACE below could just as easily have been any laye...
Hello all,We have a pair or ACEs peered in our network which is connected via a series of layer 2 switches. The ACEs are unfortunately running in a hybrid inline-bridge + one arm configuration. The story goes that the supplier that undertook the inst...
Hello,We recently migrated from another vendor to Cisco in our core (yay!) The migration seems to have gone on with out a hitch but one things seems to really bother me. We are now running PVST everwhere in the campus building up from MSt in the old ...
Hello all,We have a distribution 6500 uplinking to various access level 3750 devices. The switches are configured for STP and one port is blocking while the other is forwarding (as confirmed by the IOS in both switches).Due to some requirement or the...
Heyall..So we all know that static routing presumably does "equal cost" load balancing for traffic (since static routes are only up until the next hop this equal cost label is somewhat moot). What I'd like to know is how redistributing static routes ...
Hello,Thanks for the reply.Didn't really notice the bit about the MSFC macs since we use HSRP pretty much everywhere. But yeah I see what you're getting at ...So I get this behaviour for servers bridged by the NLB. What I don't necesarily like is tha...
Yup you guys seem to have hit the nail on the head ... vlan 999 is not being allowed through the uplinks from the core ... and vlan 999 has mostly no other member ports on any of the access vlans ... so we seem to have either disabled PVST+ or if a m...
Unless the connection is a direct point to point connection and the failure involves Site B going operationally down (Site B fails or the cable is severed....basically anything that interferes with L2 keepalives), the floating static route will never...
