Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi everybody,i just installed ACS 5.1.0.44 with the latest Patch on a VMWare virtual machine and installed the evaluation license.Everything works fine except for the "Monitoring & Report Viewer"-Tab:When i try to launch the Viewer, it opens a new br...
Hi all,we see a strange message in our WLC logs, which occurs quite often (>10 times a day):Decrypt errors occurred for client [MAC-Adress] using WPA key on 802.11b/g interface of AP [MAC-Adress]The MAC-Adresses of the affected clients are varying as...
Hello,we configured DDR Backup over ISDN for an IPSec-connection using dialer-watch. We defined a route to be watched and also interesting traffic.When the route is deleted from the routing table, the router dials the backup connection as intended an...
Hi,i browsed through nearly every antenna installation guide on cisco.com, but i still have one question:what is the recommended orientation for antennas like the AIR-ANT2422DW-R on a AP1252. Should they be aligned parallel to each other or pointing ...
Hello,we have a problem, that already occured at two locations:We installed workgroup bridges (at one location a AP-1242AG connecting to an IOS-AP, at the other location a AP-1131AG connecting to a controller-based WLAN). Behind these workgroup bridg...
Hi,first of all, i think Alex is talking about accessing the Switch via http (browser) and not telnet/ssh, so vty lines don't play a role.I am currently stumbling upon this problem as well. What works is to enter http://switch-ip/level/7/exec (Given ...
Hi Steve,we just solved the problem by ourself:Turns out it was the SSL-Certificate of our ACS-Server, which had to be reissued. After Reissueing and Installation of the certificate, the Viewer application starts in a new window as it is supposed to....
Hi,the most likely cause for this is a problem with the APs power.Do you use PoE or the PoE-Injector? Did you change the switch-port, where the AP is connected?If so, issue the following commands:- power inline negotiation injector installed- power i...
Hi,the recommended way is:- Set up an DHCP Pool for your Lightweight APs- Provide the IP address of an DNS Server and the corresponding domain name through this DHCP Pool- Add an entry in your DNS Server which resolves the name "CISCO-LWAPP-CONTROLLE...
