Hi to all. I want to config trunk and vlan between a cisco catalyst c2960xr and a hp 1920. I do this: Cisco interface GigabitEthernet1/0/48 switchport trunk native vlan 200 switchport trunk allowed vlan 6,10,100,151,209 switchport mode trunk   And th...

Hi.I need to make a trunk between a WS-C2960XR-48FPS-I and Hp1920 jg927a.The configuration on the Hp, is already done.I am interested in knowing the configuration in cisco ... I wanted to know if it is necessary to activate sfp ports (I do not know a...

Hi. I have this diagram... I want to configure the cisco 2901 with ip (10.0.0.2), and passthroug vlan 10, and 100. Network 192.168.2.0 with access to "internet"-------Router 10.0.0.1. All other router 1, 2 and 3 access "internet" also router 10.0.0.1...

Hi. I have a Cisco 2901 (2 onboard GE) and 4 interfaces ethernet module. i want to know if it is possible do four vlan: 1,2,3,4 and one trunk for that vlans....? (the trunk will be the wan of my config). Can someone give my a hand?? This is my wan "...

Hi, i want to know if its possible have to lan on this switch... (3com 4210).... i tried have to vlan, and put them different ip... but when i try, i get... interface vlan 2 Vlan-interface must be the same as Management-vlan. So.... There is any c...