About alexey.bogatikov

alexey.bogatikov · 09-02-2014

Hello!I have some problem with configuring vrf aware Ipsec (Crypto Map).Any traffic (from subnet 10.6.6.248/29) do not pass trouth router, but if i run command "ping vrf inside 10.5.5.1 source gi 0/1.737" it working well. Configuration below:ip vrf...

alexey.bogatikov · 09-29-2014

in my case it does not work. I've tried this before. See my comment on your previous post. My solution should work on all platforms.

alexey.bogatikov · 09-29-2014

hello !I resolved this problem.It is no Bug.In this ip route vrf inside 10.5.5.0 255.255.255.0 GigabitEthernet0/0.806 10.10.10.100 track 1010.10.10.100 must be changed to next hop gateway for f-vrf.After that show ip cef vrf inside 10.24.1.0/24 inter...

alexey.bogatikov · 09-02-2014

>> Additionally, here's a guide which goes through some of the configuration and troubleshooting for VRF aware IPsec: https://supportforums.cisco.com/document/51931/vrf-aware-ipsec-cheat-sheetI built my config on the basis of this post. Pre-tested on...

alexey.bogatikov · 09-02-2014

Hello Frank! >> 1. You may want to consider removing the "track 10" from your static route to eliminate any issues that this could be causing.I tried it before. Nothing changes.>> 2. If you teardown the tunnel, can the traffic from your end client (...

alexey.bogatikov · 12-24-2013

Hello,1. "ip wccp web-cache redirect in" It would work if you squid proxy have another default gateway to internet. Otherwise the traffic from the SQUID is also forwarded. You have to use different interfaces for users and squid. On sabinterfeyse vla...

Member Since	‎04-05-2012 10:57 PM
Date Last Visited	‎08-18-2017 03:55 AM
Posts	7
Total Helpful Votes Received	5

User Statistics

User Activity

IPSec VRF Aware (Crypto Map)

in my case it does not work.

hello !I resolved this

>> Additionally, here's a

Hello Frank! >> 1. You may

Re: WCCP V2 Question (Redirect https)