Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all,I hope someone can help me out with the following question;We want to buy a ISE-3315-K9 for 500 end-devices.In the price-list I found the ISE-3315-K9 but cannot find the base license: L-ISE-BSE-500=. (I think I need this license)Will the shipm...
Hi all,I have a challenge with the IPS module in the ASA5520, the ASA-SSM-10. When we start a test to connect to the webservers I get a inspection load of 100% and traffic/performance will slow down.We test with 63000 sessions per minute which perfor...
Hi all,I hope someone can help me out here with a NAT-PT configuration;I configured IPv6 NAT-PT on a CISCO1941/K9 (version 15.0(1r)M9)I cut/past the most important configuration from the router;-- ipv6 unicast-routingno ipv6 cef--interface GigabitEth...
Hi all,I have a problem to update the global-correlation. I do get updates for the signatures in the IPS but see output below regarding the global-correlation;==========================================show statistics global-correlation Network Partic...
Hi all,after a TAC level1 service request Cisco found the problem. It is the amount of traffic whats going through the IPS.Cisco told that ~20mbit incoming and ~80mbit back to the interface is total of 100mbit which is more than the IPS can handle. W...
Hi Bob,thanks for your time and reply. Indeed I just see for myself with real data that half the amount of traffic is not suitable for the IPS here.I have to find the error, I think I will open a TAC case to see whats wrong.Erik.
Hi Bob,thanks for you reply/suggestion and you understood the numbers correctly. Unfortunately the AIP-SSM-10 module must inspect this kind of load. I can test, within 8 hours time, a lower amount of traffic. I do have some questions for you:When yo...
