Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, I have the device configured in Router mode with 2 VLANs. I am able to communicate between the VLANs however my intention is to get VLAN 2 to talk to the internet and that is not working. A caveat is that I am not using the WAN port on this route...
Hi, I am trying to understand if the following policy can be applied to a Sub-rate Interface which is the Hub Site. The intent is to create a shaper for each and every remote site so that the hub cannot overrun the remote sites which have smaller cir...
Hi All,I am looking to Migrate from P2P Circuits to a Dual Carrier MPLS Service however the traffic pattern for the most part will still be hub and spoke even though the MPLS Network provides any-to-any. At the 2 x Hub Sites the subscribed BW will be...
Hi All,I was reading through the doc http://www.cisco.com/en/US/docs/solutions/Enterprise/WAN_and_MAN/L3VPNCon.html#wp401960 and in this section under dual carrier it says that in a situation where routes are getting redistributed from the PE-CE Rout...
Hi All,Currently have a setup where we have multiple SVI interfaces in a VRF on a Catalyst 6500 Switch. All these SVI belong to the same VRF. In order to achieve connectivity for hosts within the VRF to access hosts outside the VRF (Hosts reachabe v...
The default BW of an SVI is 1Gb and this is derived because the internal inband route processor is 1Gb. Pls reference the 2nd to last para in the article linked below. HTH.http://www.cisco.com/en/US/tech/tk389/tk815/technologies_configuration_example...
One more thing Is it possible that any of your hosts might have the same ip as your router. Can u confirm if the mac entry on your host matches the mac of the router. Thx
Hi, would it be possible for u to post the show run & show ip route, sh ip arp from the router and show spanning-tree vlan 172 from the switch. Also when u have a host in vlan 172 and when u try to ping the router ip do u see outbound pkts incrementi...
Hi Roger,Would it be possible for you to post the following commands from your existing device when there is no static route and also after you enter the static route. ."show ip route 10.16.0.0""show ip route 10.145.1.249""show ip route 10.1.140.5""s...
