Hi, We are having a problem with our Xerox 5745 multifunction Printer... This problem had been forwarded to Xerox, but they claim that a problem was caused by a power surge on our Cisco router. We are having a total of 8 CiscoCatalyst 2960 Series in our IT Communication rooms. We are also having 2 Xerox 7120, 4 Xerox 5745, 6 HP5200 and 300 computers - PC (HP Desktop) and Laptop (Samsung). Network : all connected to CISCO Catalyst 2960 Series Printer Setup: IP Address: Manual IP Assignment (DHCP Disabled) PC Setup: TCP/IP –RAW on Port 9100 – SNMP Status ENABLED The two machines has same firmware software and configuration settings. one machine just been installed with latest firmware Problem: On 3 Xerox 5745 display panel shows: "Network Controller booting" at 75% the system restart and go on again and again. This happens when cables are connected to CISCO Catalyst 2660. Testing done: •1. No problem, Connecting directly to laptop using (crossover cable), accesss to printing is normal. •2. No Problem, Using other switch - dLink (not CISCO Catalyst 2960), the printing is normal. •3. Not work, changing ip address; disabling all protocol; changing speed to 10MBps. •4. Not work, Switching to other port on CISCO Catalyst 2960. •5. Not work, Re-starting the Cisco Catalyst 2960 s. •6. Not work, Changing cables. HELP! Please ... ... View more

Currently Being Moderated Xerox 5745 Printer Reboots at 75% when connected to Cisco 2960 Hi, We are having a problem with our Xerox 5745 multifunction Printer... This problem had been forwarded to Xerox, but they claim that a problem was caused by a power surge on our Cisco router. We are having a total of 8 CiscoCatalyst 2960 Series in our IT Communication rooms. We are also having 2 Xerox 7120, 4 Xerox 5745, 6 HP5200 and 300 computers - PC (HP Desktop) and Laptop (Samsung). Network : all connected to CISCO Catalyst 2960 Series Printer Setup: IP Address: Manual IP Assignment (DHCP Disabled) PC Setup: TCP/IP –RAW on Port 9100 – SNMP Status ENABLED The two machines has same firmware software and configuration settings. one machine just been installed with latest firmware Problem: On 3 Xerox 5745 display panel shows: "Network Controller booting" at 75% the system restart and go on again and again. This happens when cables are connected to CISCO Catalyst 2660. Testing done: •1. No problem, Connecting directly to laptop using (crossover cable), accesss to printing is normal. •2. No Problem, Using other switch - dLink (not CISCO Catalyst 2960), the printing is normal. •3. Not work, changing ip address; disabling all protocol; changing speed to 10MBps. •4. Not work, Switching to other port on CISCO Catalyst 2960. •5. Not work, Re-starting the Cisco Catalyst 2960 s. •6. Not work, Changing cables. HELP! Please ... ... View more