Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,Wondering if it is acceptable to mount a C9500-24Y4C with only a two-post mount to the front, or if the 4-post kit is required. I'm asking because the front and rear posts are closer together than the switch's length, making a 4-post mount diff...
Hello,Wondering if someone here has experience designing OT process control networks and implementing QoS on them.Thinking about designing a 3-tier network with L3 connections between the core and distribution switches. (Cisco switches)Thinking of us...
I need a copper 100mbps connection for a legacy system, and according to the optics compatibility matrix, it appears to be supported, but not sure if it will work at 100mbps. https://tmgmatrix.cisco.com/?si=C9500-24Y4C
So to actually implement this, would I create the class and policy map similar to your example on the core and distribution switches, and run service-policy output Example on the uplinks on the distribution switches going to the core switches and the...
Thanks for your response.If I simply trust DSCP on the distribution and core switches without creating a policy map, will they be able to prioritize the correct traffic? I was looking at this Cisco/Rockwell document: https://literature.rockwellautoma...
