Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
My MR 36H is alerting "running in low power mode"I have a Meraki 802.3at POE injector and only 50' of good quality Cat6 cable.Can you help me diagnose what's wrong?TIA
I have a VERY simple network:Internet - MX67 - MR36HA few vlans on the MX and SSID's on the MR mapped to them (vlan tagging)Ports on the MR36H mapped to a specific SSID (port profiles) When I assign the MX port that the MR connects to to Native VLAN ...
Trying to turn up a new network - and getting this error message: xtra: no_offers_received, vap: 0, vlan: 1. Can't figure out why. Appreciate guidance.
I'm trying to set up port profiles on an MR36H - but I'm confused.The dashboard config settings list Ports 1 through 4 - BUT the device has an "unmanaged" port and three other ports (numbered 1 through 3).So - I am confused. Can I actually put a por...
I don't have a PoE capable switch - that's why I purchased the PoE injector.This is a home network. The direct connection is to an MX67 - on a straight run of shielded Cat6 (via the PoE injector - of course).That said - the condition has now cleared...
