Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
OTVHello, I have a L3 network inter-sites but using SVI over trunks because I need to extend VLANs L2 intersites too. One of these VLANs are SVI that permit routing intersites. As I know, OTV join interface must be L3, but I have a L3-SVI. I would li...
Hi, When I try to switch call controls to my terminal phone 9951 it is rejected. However models 8945 and 6945 are right. Version CUCM is 8.6 and IP phone are using firmware sip9951.9-4-1-9 ...
Hi, I recently had problems with our Server Network and after capture network traffic I realized that there are a lot of bad TCP traffic from servers: TCP out-of-order, Dup ACK, Retransmission. I was suspecting of my FWSM and moved servers ne...
Hi, I would like to know if will be possible to have dynamic routing working into FWSM with multiple context in the future. I need this because I have two OSPF process working outside and inside de FWSM, so the FWSM should have the posibility of a...
Hello, many thanks for your reply. I will consider this solution but firstly I need to check the license because I haven´t VDC license right now (I have LAN_ENTERPRISE). Another option I am lookng is to switch to VxLAN with MP-BGP although I bought O...
Thank you Sergiu, my question about a join-interface over trunk has been cleared. I have 4 sites in my company, each of them with one border router. I have point-to-point links bewteen them drawing a square. The point-to-point link is 802.1q spreadin...
Hi again, I don´t believe that FWSM is falling into saturation because now I have low traffic passing through and the captures shows some TCP bad traffic yet. Could you let me know a document to understand the counters when I use "sh np blocks" ...