Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I'm trying to use the http gui to change the channel used on my AP, but cannot make it happen. I've tried changing the dropdown back from Least Congested to a specific channel, no luck. And I've tried limiting the channels used in the Least Congest...
I've established a site-to-site connection between the devices, but cannot get any traffic. Both ends can still reach Internet, but cannot ping any addresses either way, nor browse or other traffic. I have no idea how to debug, can post anything fo...
I've been able to, with much trial and error, establish the tunnel between my main office, the ASA, and the remote office, the RVS4000.However, I can't get traffic to work through the tunnel. I used the wizard to setup the tunnel on the ASA end, and...
Unfortunately, can't ping anything, either direction. Cannot browse windows shares, or ping, but can rdp to machines that are enabled. Any thoughts?Thanks again, gene
I see this in the log from 5505, trying to ping from the 5510 side. Looks like it is getting into the 5505, but not back out.3Aug 09 201011:54:09305006172.16.102.50regular translation creation failed for icmp src inside:192.168.1.70 dst outside:172....
To me, the untrained eye, they look the same as previous post. Thanks, geneResult of the command: "sho crypto ipsec sa"interface: outside Crypto map tag: outside_map, seq num: 1, local addr: 67.60.168.34 access-list outside_1_cryptomap_1 ex...
Thank you for looking, I've applied those commands successfully, but I still can't ping across, either direction.I had this working with a cisco RVS4000 before replacing with the 5505
