Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We are setting up a VPN tunnel with a vendor and I want to only allow Pings, and one specific port. I thought you could do that through the crypto map on the ASA 5510 but it looks like it has to allow all IP traffic and then you filter out using a VP...
Don't worry this isn't another load balancing question. I know that is not possible.But I have 2 ISPS and I would like to use 1 for my VPN tunnels and 1 for my internet.Right now I just have my last default gateway as going ISP1Interface 0.0.0.0 ...
Whats really annoying is Prime is supposed to be a single pane of glass, not a single pain of glass. I just want it to pull SNMP data from the Nexus, show me utilization etc. I dont need it to configure, but I want to see the data. With Prime I can ...
SO I think I may have it working now.... it looks like I needed to add some NATing in order for the Comcast modem to send the traffic back correctly. Does what I did make sense? I ONLY want NATing on the Comcast interface (Vlan 1001)Current configura...
