About kaggenuchc

kaggenuchc · 01-27-2010

I have a client who has 6 switches currently configured on their local LAN. One switch which is a Catalyst 2950 has the Device Manager loaded, and when you access the site using the IP address by the URL http://206.x.x.x it brings up the switch Web G...

kaggenuchc · 08-25-2010

My activation code is *999 (but it is also enabled through the scheduler during closed business hours)My phone configuration is as follows: (for security reasons I have removed any information not pertinent to the issue)ephone-dn 18 dual-line numbe...

kaggenuchc · 08-25-2010

Normally I don't like to open up old discussions on a forum, but I am experiencing the same issue as the original poster. This is a big issue for the client who uses the system, as this feature was sold to them as part of working solution on the pho...

kaggenuchc · 01-27-2010

This is a good idea, but sadly I went into the GUI and tried to remove the password and it told me that I had to specify a password. Would not let me set it to blank. By default the WEB GUI uses the enable password on the Cisco. Currently the only...

kaggenuchc · 01-27-2010

Thanks for your quick response. I had tried using that command earlier in my troubleshooting steps. I have even gone as far as to erase the current configuration using write erase, reload (with no as my response to save the config). Still the WEB ...

Member Since	‎01-27-2010 02:24 PM
Date Last Visited	‎09-18-2018 03:27 PM
Posts	5

User Statistics

User Activity

HTTP access to Cisco Catalyst 3560 with no Authentication

Re: Single Number Reach and night mode

Re: Single Number Reach and night mode

Re: HTTP access to Cisco Catalyst 3560 with no Authentication

Re: HTTP access to Cisco Catalyst 3560 with no Authentication