Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hey All,My MR AP(CW916I) device switched to repeater mode. I rebooted it, but it remained in repeater mode. I replaced it with an identical MR, which worked fine on the same port. I then tested the original MR on another port in the network closet, b...
I want to setup my MX-250 hubs in active-active mode. Currently the throughput on one hub maxes out occasionally, causing issues. Is it possible I can split my spokes on each hub?
I did opened a case, but they asked to do the layer1 stuff first which I did.If this is a hardware issue then why the new one switched to repeater mode? and the older one started working.
