Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I recently deployed MR33 APs on a network using Cisco 2960X PoE switches. I set the SmartPort role of the ports connected to the APs to the "Access Point" role.The switch periodically checks to make sure the proper roles are applied to match the conn...
I have been trying to make some config changes on my MX and that is not working either. My MX status page shows config is out of date going on 50 minutes now. Could this problem also be affecting MX devices?
Here are some questions that I would like Meraki to address:For the purpose of displaying clients on the dashboard, why does Meraki place a higher weight on cryptic MDNS names rather than easily identifiable names?I’ve been using Meraki for over 6 ye...
I disabled CDP on the ports connected to access points and they are now properly detected as access points by the SmartPort check. Thanks for the help!
