Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I'm creating a VPN to send traffic to a cloud security provider. My Cisco ASA is behind a device that performs NAT. I sent interesting traffic both real and simulated (packet-tracer) but the tunnel never initiates. Captures on the next hop device aft...
Hi guys,
I have read several of the articles on the same subject but none seem to apply to my situation. It doesn't seem to be either Java or missing configurations.
ISSUE:
I upgraded my ASA to 9.5(3)9 with ASDM 7.6(2) and put it in an HA pair. When ...
Device:FirePower 7115 running version 6.0.1 (no malware license)
In Host Attributes you can edit the operating system if the discovery gets it wrong. There are versions of OS that are not listed eg. newer versions of Juniper etc. What software updat...
Device: FireSight Management running version 6.0.1
If another user logs into the management gui and does a change like disabling an interface, or Firepower recommendations or a policy, but doesn't push the policy or not fully applied the changes. Is ...
The cloud security service proxies/intercepts ALL outbound traffic, so the destination has to be ANY. In other words, when any device on my network attempts outbound communication with the Internet it will be sent over the tunnel towards the cloud se...
I was able to solve the issue. The ASDM Launcher was having issues performing the SSL handshake:
OK button clicked
javax.net.ssl.SSLHandshakeException: Received fatal alert: handshake_failure
Once I removed the Trust point from the inside interfa...
What I am saying is when you try to configure for an OS that didn't fingerprint, there is no option to setup some specific OSes. eg I am doing a manual OS for Juniper that was fingerprinted as MS. If I do a custom then I don't believe I will get vuln...
Audit and Deploy is ok but I guess there is no real good place to get the info. Sometimes the description given under deploy is not descriptive enough.
Thanks!
