Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I went through the list of Meraki options for selecting a time zone in the "Network Wide > General" settings. I selected "America - Beulah, North Dakota (UTC -5.0, DST)" even though I am in Fort Worth, Texas. I don't tend to mess with time zones much...
I am trying out a MX64 and I have a VPN I need to establish between the MX and a Sonicwall TZ600. I found this link to create the tunnel but I noticed on the Sonicwall side I had to specify a specific Primary Gateway Address in order to use a Main Mo...
Throwing in that my SSID is down as well. Last year I was almost sold on switching all our P2P VPN devices with Meraki ones. Decided to renew with what we had, I am so glad I dont have 27 stores offline right now. Just a little bit of WIFI outage isn...
Is this on all MXs (i.e MX84 and higher)? I've been considering and actively testing replacing our sonicwalls with Meraki devices. If none of the higher tier devices are able to filter SSL traffic this throws a big wrench into my plans.
Final Update from the ticket I submitted:Thank you for reaching out to Cisco Meraki Technical support.From what I understand from your question, that is correct that if the IP addresses from the ISPs change you do need to update them on the Meraki Ma...
