Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
My switch MS120-48 is running MS 18.1.8.1 / CS 17.2.3 and it is adviced to upgrade CS to IOS-XE 17.15.1.9 or higher. When I want to schedule or plan the upgrade I get an "Action required before upgrade"Is this a general warning or is there realy somt...
Hi,On our MX67 SD-WAN we have an Advanced Securtiy subscription. I have noticed some mails about securtiy issues with topics like MX security report for organization....When I open them I see that the mail is about a security warning that occured e.g...
MX67WAN1 on ISP1WAN2 on ISP2LAN1 on 192.168.1.0/24LAN2 on 192.168.2.0/24Load Balancing OFFPref WAN1Flow Pref Rule:ANY 192.168.2.0/24 to ANY via WAN2When I browse to MyIP.com it shows my ISP2 WAN IP > OKWhen I do a tracert on my laptop only on LAN2 I ...
Running MX67 with latest stable firmware DNS changes in WAN1 are not saved. I have a new ISP and want to change the IP4 DNS values on the WAN1 side. Currently they are 8.8.8.8 and 1.1.1.1. I follow the next steps: Sec & SD WAN > Appliance Status Upli...
MX67 on latest stable version MX 18.211.5.1We have a new ISP with 1Gbps link We connect CAT6A to the ISP CPE device Using static IPV4 provided by ISP on WAN1 P3 connected a laptop on VLAN1 192.168.1.0/24 DHCP When nothing else connected, just this la...
It has a fixed IP in the default VLAN of my MX-67. And it mentions the correct WAN IP. In Routing and DHCP of my switch nothing is configured since I use it only as a L2 switch so far (small company).
After disabled Thread Protection the speed increased to the max. ReEnabling it drops the speed again to 200-400Mbps. Explaned by the supportdesk as well.
Figured out it works when you change DNS entries on the WAN side via <localip>/#configure screen. Sounds like a bug to me that changes are not applied via the cloud portal.
The speedtest I run is provided by my ISP. When I run this one directly on the WAN connection (MX67 replaced by a laptop) I measure around 1Gbps constantly. When the laptop is replaced by the MX67 I measure once 700Mbps, then constantly around 200Mbp...
