Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi I would like some advice on how to redistribute routes between three independently managed private networks. Currently: See attachmentThe two buildings managed by Company 1 are connected by 4x1GB fibre channel ports on Cisco 3750G Standard Image s...
HelloPlease see the attached diagram.Router 1 is in a different building to Router 2. There is dynamic routing information passed between all routers.Is there any reason to setup HSRP between Router 1 and Router 2?And is it possible given that all i...
HiI would like some advice on how to redistribute routes into a MPLS WAN which is fully managed by our service provider (BT IP Converge).I have been informed that the service provider runs BGP over the MPLS WAN and I would like to advertise STATIC an...
I have a problem with SSL VPN client for webvpn.I am using version client version 1.1.3 and until recently the ASA 5520 was working perfectly. However I am now getting the following error message after authenticationthe ssl vpn http response code re...
I have a problem with a site to site VPN tunnel.I have setup a tunnel with a remote site (138.3.0.0/16) to my site (10.212.0.0/16 10.147.108.0/24). The remote site can initiate Phase 2 but does not get a ping response.Phase 2 is not even attempted w...
HiThanks again for the reply. To clarify could anyone answer the following questions: 1. Is dynamic routing needed in Company 1?2. Given that only 4 devices are managed by Company 1 will RIPv2 work, even though routes will be shared with Company 2 an...
Hi Thanks for the reply. Unfortunately I am not sure as to the exact routing protocols usedIn Company 2 - I think they use BGP, but they have offered to redistribute the routes into any routing protocol Company 1 wants.In Company 3 - I think they us...
Thanks for the reply:The N2_outbound access-lis:access-list N3_outbound extended permit ip any any is applied to the inside interface:access-group N3_outbound in interface insideand permits traffic from the inside to dmz3.There is no statement that a...