About christoph.bloos

christoph.bloos · 02-11-2010

Hi all,I have a problem with two VLANs linked throu a crossover link in each VLANPlease see picture:I can't access the routers from the VLAN20 IP 10.10.1.3 and the other way roung.The same config is working fine on a 4507 switch.What is wrong?Can som...

christoph.bloos · 02-16-2010

Hi all,I have found a way where it is working:I have added an IP for the VLAN 10 Interface VLAN 10 ip address 192.168.0.1 255.255.255.0Than it is working! But this IP is not used...And It is also working without ip routing enabled!If thi...

christoph.bloos · 02-12-2010

Hi Jon,I am pining from the 3560 with sourch interface 10.10.10.3If I connect a device via access port to VLAN20 (laptop) with IP 10.10.10.4, I can reach the 10.10.10.1 and .2, also in other direction.below the "sh spanning-tree"gi0/1 is a router (1...

christoph.bloos · 02-12-2010

Jon,That is exact what I am dooing. But it is not working on the 3560. I also replaced the IPS with a crossover cable, wich causes the same issue.But it is working on two diffrent 4507R. (Same IOS Version 12.2(20))Christoph

Member Since	‎02-11-2010 01:38 PM
Date Last Visited	‎05-05-2021 12:47 AM
Posts	4

User Statistics

User Activity

Layer 2 traffic between VLANs on a 3560 Switch

Re: Layer 2 traffic between VLANs on a 3560 Switch

Re: Layer 2 traffic between VLANs on a 3560 Switch

Re: Layer 2 traffic between VLANs on a 3560 Switch