Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
My R3 acts as a frame-relay switch connecting R1. The frame-relay circuit is up. However, R1 is unable to see R6 thru ospf routing. Attached here is the config & diagram to explain. Hope some1 can help this novice. Many thanks.
Hi all,I got the following error doing a debug on a frame-relay & couldn't find any doc that explain the problem. Hope some1 from here can help. The error as follow:"Serial0/1:encaps failed on broadcast for link 7(IP)"
Hi,I am on a ISDN dial to a remote router.I encountered a problem whereby I cannot see the LAN segment over the remote router when CEF & fast switching are enabled on both the dialer & gigaEthernet interface. However, when CEF & Fastswitching are dis...
Hi,I had recently requested an upgrade from my service provider on one of my frame-relay site. Is there a way to verify if an upgrade has been done on my pvc?Regards.
Hi Nara,I had tried to change R1 and R3 to area 0 but it doesn't seem to work. I guess it is something to do with my R3 connectivity to R1 which is a frame-relay. A show ip ospf interface on R3 doesn't seem to list the serial int connecting to R1 as ...
Hi Logan,Hope the following helps.access-list 100 permit ip 1.1.1.0 0.0.0.255 any route-map ISP1 permit 10match ip address 100set ip next-hop (ISP1 GW add here)ip local policy route-map ISP1
Hi,The status deleted indicates that the PVC has been erase from the service provider database. If the pvc is configure but not activated, it will appear as "Inactive". Hence, i would recommend to check with your provider for confirmation. Hope this ...
