Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
A customer trying to implement PVLAN in the network. It's a simple setup, see attachment, with one dot1q trunk in with two secondary PVLAN and one trunk with a primary PVLAN. This works well if only one secondary VLAN is used and configured as “isola...
The customer lost the PSK but kept it in production. Now they installed a new controller and need to add the PSK in the new WLC. Seems to still be problem to use template and PSK in WCS (old bug). The key seems to be corrupt in the new WLC.Is there a...
Hi That no problem. Just follow the guide in one of these documents: Chained certificate (think you need to upgrade your system to use chained certifcate) :http://www.cisco.com/en/US/products/ps6366/products_configuration_example09186a0080a77592.sht...
Hi Chris,If many users share clients, it can be problem that all users certificate have to be on the shared hardware. I had this issue in a school, and we ended up with using EAP-TLS and only hardware certificate. You don’t get full security in this ...
Hi Peter, Thanks for your answer. The reason the customer want to implement PVLAN is that they have many servers that should not have access to each other, but is the same time need access to a backup server. It is possible to implement PVLAN within...
It depends an the size of the network. If you only have one or two WLC and they are close to the DMZ, you can easly use VLAN to isolate guest trafic. But if network gets bigger and you have many WLC and with a router hop away from the Internet exit, ...
Hi,You don’t need aggregate links between the two controller to balance the load. Just let the access points discover both controllers and they will take care of the load balancing. The AP collects all information about the controllers they found dur...
