Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi everyone, can anyone help me with this problem.Last weekend our internet connection started running very slowly.Between the B.T router and our network is a 2950 switch. This switch is showning excessive single and multi collisions. Can anyone poin...
I have 3 3560's on a fibre ring terminated on a gbic blade in a 6509.The two gbic ports on the 6509 are configured 'set trunk n/n on dot1q'.The gbic ports on the 3560's are 'switchport mode trunk'. I can ping all 3 3560's from the 6509 but I can only...
I have installed a new 2950 switch, connected to a 6509 with GBIC's.I cannot ping the 2950, it is on the same subnet as the 6509. If I run 'sh cdp n 3/9 detail' on the 6509 it gives me details of the 2950. If I run the same command on the 2950 it giv...
JonThanks for that, I will check with B.T.I have a meeting at 12:00 and then have to go to a remote site to install a new server.I may not get a chance to look at this again today.Mike
Hi JonI was told by the B.T engineer that it had to be 10Mb/half.I have asked them again if it can be set to 100/full.The link has been working for a number of years, the collisions only started last weekend.I have attached the diagram as a .bmp file...
Hi JonI checked the router port on the 2950, its set to 10Mb/half, confirmed this is as it should be with B.T.I have changed all the CAT5e cables and swapped out the switch.I have attached a vsd file of our setup.The switch 'OUR NETWORK' shows no col...