Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a 4 sites that has only thinclients an ASA 5505 and a 3550-24-pwr switch, all are connected to a FIOS connection. I am using the ASA doing DHCP and it is the default gateway at all sites. We are putting all sites on a MPLS network and using t...
I have 3 windows 2003 terminal servers setup for load balance using Windows Network Load Balance Manager. IP addresses 192.168.1.14, 192.168.1.15, 192.168.1.16 Cluster IP 192.168.1.40 multicast. I have a remote site connected via site to site VPN tun...
I am setting up active\standby failover on 2 ASA 5510's. I am also setting up a backup ISP link. Now should I set the monitor-interface on the inside and backup interfacesSo that if the inside goes down it fails over to the secondary device and if t...
I am looking to see if this is possible, not config details yet, with the hardware I have now. I have at the main office 2 T1 connections and a ASA5510 with security+ lic and 6 remote offices with 1 broadband connection and a ASA5505 each. I have no ...
I have an asa5505 Ver 7.2(4)that I am trying to get a SSH connection with SecureCRT but I keep getting Password Authentication failed. This is what I have entered.ssh 192.168.0.0 255.255.0.0 insidessh version 2username Name password Passwordcrypto ke...
I have setup wireshark on my 192.168.1.0 subnet and setup a packet capture on the ASA5510. On the wireshark I see SYN packets coming in from my machine 192.168.100.102 to the cluster IP and I see SYN,ACK packets Src the cluster IP with the mac addres...
Whe you setup an ASA for failover is it just checking that it's own interfaces are working and passing traffic or what it is connected to, like the port of the switch to the inside network and the ISP modem to the outside or both.
I have not come up with a solution using the ASA 5505. But I am looking at failover DNS were you pay for a service that checks a public IP if it gets no response it redirects the associated DNS name to the backup public IP address.
Thanks for that link. Let me rephrase my question now. On my ASA 5510 I have 6 site-to-site VPN connections. If I now setup the "Redundant or Backup ISP link" Do I also attach my ACL's and cryto maps to the backup interface? Also if the ASA5510 does ...
