Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all, I work in a shop where it's usual to configure DHCP pools for switches. A colleague to mine struggles with configuring DHCP reservation for Meraki Switch Stack - is that practically possible? It's impossible to configure the same IP address r...
Howdy, I have Teleworker Z4 device at home and config that's received from Meraki Cloud tells it to create Mesh VPN with 80-ish other VPN targets. My problem is, that roughly 50% of the tunnels isn't built. These aren't the same tunnels everytime, e....
Aight, so my colleague that has the stack on his table (different site) has performed a test with following results: DHCP reservation was created for active (stack-master) stack memberActive stack member was forcibly disconnected from powerNew switch...
Thank you. I believe this is the closest to answering my question. I will conduct an experiment to figure it out empirically and get back to this topic.
Thank you. I should've write it in my original post - the switches in question are 9300. As @alessandrodematos wrote, these are different in comparison to lower class switches - meaning 1 IP is assigned to the stack members. I am curious about the de...
Thank you for the response, would you be so kind and elaborate a bit more about MS390 and C9300 models - i.e. what is the difference in comparison to lower class switches, e.g. 210? Thanks!
