Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Where do you put your bandwidth statement on your Frame Relay interfaces? I have OSPF on Frame Relay and want to put the bandwidth statement in, but am not sure how to apply it. My confusion is with these two questions:Do you put it on the main seria...
I have a situation where I have a medium sized Frame Relay network with OSPF as the routing protocol. It is a heirarchical partial mesh, with two central data centers, a number of primary sites and a larger number of secondary sites. My question has ...
Was wondering if any of you have seen a problem similar to this one. Not sure how long it's been going on. We found it while logging some email traffic, and noticed that a great deal of traffic is from the second and third servers listed in the MX re...
In my last message about "PIX intermittently stops AAA with CiscoSecure ACS/NT", I was asked if I was using the older 'aaa authentication include...' command to invoke CiscoSecure ACS / TACACS services on my PIX 520 with OS 6.1(1). That raised a big ...
Hopefully someone has heard of this...I have a customer with a PIX 520 (with 6.1(1)), which does AAA (Authentication Authorization Accounting) with CiscoSecure ACS/NT to authorize users to access the internet from inside the firewall. From time to ti...
Assuming you will want some 10/100 ports at the head end location, yes you would be stacking them. The 3550s, 2950s and 3500XLs are all fixed configuration stackable switches. The 3550 switch I mentioned only has 12 total ports: 10 GBIC ports, and tw...
Another way to shave more costs is to get an authorized refurbished switch from Cisco's refurb program. Tech Data is one of the three vendors under the authorized refurb program. I would recommend Catalyst 3524XL or 3548XL switches. I use alot of the...
I would go with a stackable solution if your wanting to stay on the cheap.Look at the Catalyst 3550-12G Switch (10 GBIC-based Gigabit Ethernet ports and two 10/100/1000BaseT ports). This will give you the Layer 3 switching between subnets, and fiber ...
I have a customer who has 5 LS1010s each with a 4-port OC-3 PAM and multiple T1 CES PAMs. We tried to use them for T1 multiplexing over single mode fiber on their campus Nortel SL-1 PBX. We spent a year trying to get it working, and never did. The re...
