Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,In a remote network we have an MX, running MX 18.211.2.It has an MG21E-WW running MG 3.101 attached to it, one cable attached to WAN2/Internet2; the other on port 12 (only for PoE purpose).Lately, the MG goes offline for several hours per day whic...
I would like to post a kind of feature request here. Call it "improvement of graphs".What bothers me is that some graphs are interpolated.As an example: during a nightly outage of a MG21 (unfortunately, that happens now and then) one can see network...
While troubleshooting reported issues from a device 5GHz-only client, I was zooming in to it by selecting its MAC / IP address.The device has been connected and working all the time, and that is confirmed in the dashboard.But when I switch to the tab...
Is it possible to see which client usues which WIFI protocol? I know Meraki does show what protocols a client is capable of, but I can't find where to see what protocol a client is actual using (802.11ac or 802.11ax)...Greetings from Holland
A collegue confirmed he did not see the information in his tenant and client devices too:So I submmitted a support case as it may be a generic issue for our european zone
