Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
HiCan someone on the back end disable IPV6 on the WAN interface? I called TAC they said no, but I am finding info otherwise.I need it disabled & the ISP can not do it in bridge mode on the modem.Thanks
HiUpgraded this weekend all our AP's to this version. A mix if MR36/46/CW9178I.All the CW9178I AP's that have uplink port 1 connected, no longer pass traffic. I get zero uplink traffic. If I move the port to 0 I get traffic & normal operation. 9 o...
HiMigrating to Meraki. I have a non Meraki firewalls. Migrating to MX-85's for 22 remote offices. I currently have 1 VPN configured. I use the same subnets to each location to allow connection to home office resources.I attempted to add another VPN...
The 2 are an Atrium install So yeah they are that high. No option to lower the mounting. Downgraded those 2 for now. Support told me either port will work. They are investigating my report & may have a fix in a future update.Thanks
Support said I have to use 1 big tunnel instead of trying to set up 22 of them. The overlaps are voice vlans so our antiquated phone system can inter office 4 digit dial the 22 offices...That isn't going to work with the Meraki MX/Fortigate. Until I...
This is what I get..."The settings you requested require confirmation. Please review the following list.The VLAN subnet 0.0.0.0/29 overlaps with remote VPN subnets on non-Meraki peers Fortigate (0.0.0.0/24) and Fortigate Secondary (0.0.0.0/24). IP tr...
So...ExampleMy core office has a data subnet of 172.16.1.0.I need to have 22 remote sites connect to this subnet.Each site has it's own local subnet that is not the same.Remote site 1 is configured.I try to configure remote site 2 & then I get the du...
