Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello everyone.I have an MX68CW-WW that I need to connect to an ONT (Telekom fiber modem) with an Ethernet cable.Telekom uses VLAN 7 for internet access. How can I tag port 1 on the MX to VLAN 7?If I go to "Addressing & VLANs" page I can do only for ...
Hello everyone!Excuse me if this question is banal, but I wanna be sure before buying, since the expense is not actually low.I have an office with an MX65W installed. Now the company create a new site, and both have to be connected in VPN.If I buy an...
Hello to all! I'm new in configuring switches and I would appreciate any help to solve my problem.In our headquarter site we have a Meraki MX, two Meraki switches (an MS220 + an MS120) and an Hp maganed switch. The MX is connected directly to the MS2...
Hello to everybody!I'm subscribed to this community since I'm experiencing a blocking issue with my security appliance, and the support is lacking to help: it's a month since we opened a case, and we are still without a solution.Since the upgrade fro...
Thank you very much to you both!I never paid attention to that field!Could I ask another thing?It seems that MTU required is 1492, so I suppose I have to lower the standard 1500. Could you please confirm that this change has to be done calling Meraki...
Finally it works also with media converters!I elaborate on it, and I found that the MS120 wasn't connected to MS220 directly, but it was connected to the HP instead.So: MX --> MS220 -- fiber --> HP -- media converter --> MS120.and the HP had incorrec...
I just ordered a fiber cable, I already have a transceiver to use with it. Tomorrow I can test the direct connection between two switches without media converter. I'll let you know! Thanks
Thanks for your reply!I have this on ports connecting each other switchTypeTrunkNative VLAN1Allowed VLANsallAnd this is the configuration on the port connecting the device (3 is my new VLAN):Port statusEnabledTypeAccessVLAN3Voice VLAN--Access policyO...