Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
(Shoutout to @ShaunBirrell for his help with this and pointing me in the right direction. Sharing this with community so others can review, edit and use for their own deployment exercises.)
This guide details configuring the Meraki vMX in Azure for ...
Set up a vmx with a /28 subnet on an existing vnet. Need to configure anyconnect - it obviously can't be on the /28.Does the anyconnect address space need to be within the existing vnet?
Hi - have 4 downstream autovpn MX units all spoke with 0.0.0.0 to Azure vMX. Anyconnect clients at Azure. Need to add 3 non meraki VPNs. 2 of them need the same exit for MX connected and anyconnect connected clients. Can the non-meraki VPN be tagged...
In routed mode 19.x - vmx-LAN and vmx-WAN should be separate subnets under your workload vnet. then in your host subnet under that vnet you can then change routetable to make the default 0.0.0.0/0 to point to the vmx-LAN IP. just make sure that you ...
@jean.halais you deploy the vMX with the additional interface then upgrade to the 19.x firmware train after it is installed. stable release candidate is 19.1.7.2
