Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello community,I have many of these log entries in my connection logs: Client made a request to the DHCP server, but the DHCP server rejected the client's request. Client made a request to the DHCP server, but it did not respond I was already ab...
you can create a group policy and apply this to the client directly.You can find this in the documentation:Creating and Applying Group Policies - Cisco Meraki Documentationregrads
Hi,at the moment there is no SFP28 from Meraki itself, you have to take the Cisco modules. Attention, it is only supported from a certain firmware.Small-Form Factor Pluggable (SFP) and Stacking Accessories - Cisco Meraki Documentation*Note: The SFP28...
I would't say easier, it's different. When you configure a regular IPsec peer you won't have a redundancy when using physical WAN addresses. When you use the VIP the IPsec tunnel can move to the secondary MX.
Hi,Use MX uplink IPs: When using this option, the current Active MX will use its distinct uplink IP or IPs when sending traffic out to the Internet. This option does not require additional public IPs for Internet-facing MXs, but also results in more ...
