I know this sounds unusual but I seems like Unity may be too fast on my most recent implementation. If a user on a Cisco IP Phone hits the message key it seems like Unity starts playing the greeting or prompt before the IP Phone (I am using 7960/7940...
Cisco has a feature in CallManager 3.3 called Cisco Call Back or CCB. If you dial an IP Phone and the line is busy a call back soft-key appears. However this works only station to station (IP Phone to IP Phone). I am still looking for a camp feature ...
Since Unity 3.1(5) transcodes on the fly, how can I verify the codec that a connection (to a port) is using?I want to make sure my remote CMs are connecting via G.729 and local CMs at G.711.
I am trying to achieve a simulated camp feature where a phone will forward to Unity when busy and then supervise transfer will see the subsriber's extension as busy and hold the call or record message. I can get this to work if I call Unity first an...
Create a cti route point with a dummy number. Forward this number (cfwdall to VM) to voice mail.Add the dummy number as the last number in the attendant console hunt and check the box that says always route.This should work. NOTE: the dummy number is...
I believe that VAD (voice activity detection is enabled by default on H.323 dial-peers.Either diable VAD on the dial-peer (or voice port) no vadorinsert comfort noise when vad is in use.comfort-noise
I too upgraded to 6.02 and experienced the exact problem last week. I am running CallManager 3.3.3 SR4 and have now loaded the cmterm-7940-7960-sccp.5-0-4.exe Version 5.04 load for the 7960/7940s and the problem was fixed.Hope this helps.
I am running P00306000100 which is the latest load for CallManager 3.3.3. This is also the latest for CallManager 4.03. Maybe I'll back up a version and try the load that comes with 3.3.3 SR4.
I don't know why mailguard or (fixup protocol smtp in newer versions) would need to be disabled in order for pop3 access to work? Since pop3 is an entirely different protocol and mailguard or fixup(see below) is only limiting SMTP based commands.When...