Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Meraki MX I can't seem to configure IPv 4 inbound source and destination! what are my options then? the outbound is configurable with the ipv4 but the inbound ?! i need to allow specific traffic using inbound as there is an implicit deny
hello Team, I wanna Connect the Non-Meraki AP to the Meraki switch. knowing that I have three SSIDs configured. However, I don't want the end users that connect to the non-Meraki AP to use the same SSIDs of our domain network. I want the AP to assign...
Hello Dears, Today upon checking the dashboard I noticed one of the MX indicators next to it is yellow in color. with a note that says bad internet connection! I checked the users working in that branch and they don't have any slowness not latency is...
Hello Dears, I want to ask about the Meraki MR connecting methods .. should I connect it to Meraki Switch or to the MX directly. ?? also, does both work or not? what the best practice as well thank you
Hello Dears, I have a Meraki setup here and I'm looking for a solid answer. I do have Co-term license mod applied for all devices. and all my license limits and device counts are equal. so I need to add new MR ( access points ) devices to the networ...
Dears @danjns @Karsten Iwen Thanks a lot for your response. for that case, I get it now. but what about another scenario, for example on the non-Meraki AP to disable DHCP and let my network DHCP assign IP for those end users connected to the non-M ...
