Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all,I haven't been able to find a solution to my specific issue anywhere but please correct me if this is documented somewhere!We are looking to build out a Campus SDA fabric and our design called for configuring L3 P2P /30 interfaces (no switchpo...
Hey folks,Sorry if this has been answered elsewhere but I couldn't find anything on my search.I am trying to see if there is any ability to provide users with write-access to specific functions such as applying the 'Blocked' policy to a client in the...
This was my hunch given I found no documents or posts to support configuring L3 for border handoff. I am actually fine to use it as it is built by CC with the SVIs and L2 Po off to the ABN, I'm just looking to get my ducks in a row before I report ba...
Wouldn't have affected my deployments at least as we're exclusively Wi-Fi 6/6E. I note there is a new known issue introduced with 29.6.1 "In high capacity wireless networks APs may experience instability when the “Client Balancing” or "Band Steering"...
That is a rabbit hole I probably couldn't answer entirely within character limits! A couple of points though:- I wouldn't normally equate a warehouse environment with high-throughput client requirements. Is there a specific need to maximise throughpu...
Depends what you're looking for and where in the world you are. If you're looking to just test 'max throughput' you'll need to set channel width to 160 MHz and make sure you're close to the AP. Your 'max speed' might be less than the same test perfor...
