Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
HiThere's a setting in "Wireless > Firewall & Traffic Shaping" called "Layer 2 LAN Isolation". Previously, our wifi has not had this setting enabled, but another administrator on the network recently enabled it, and explained to me that this signific...
We already had an existing network created by the more knowledgeable IT admin designed to accommodate printers. Placing the printer in this network via an ethernet cable does allow computers connected via wifi to the main network to connect to the pr...
@jpm122 wrote:Layer 2 isolation is only in bridge mode, not Meraki NAT mode, so there you go.You could turn on Meraki NAT so everyone gets an isolated subnet to themselves, and then add an ACL to permit traffic to just the printer IP address on the L...
@simple818 wrote:According to this https://documentation.meraki.com/MR/Firewall_and_Traffic_Shaping/Wireless_Client_Isolation"With Client Isolation enabled, clients will only be able to communicate with the default gateway and will not be able to com...
@simple818 wrote:I believe the Layer 2 isolation would work counter to your goal here. It will isolate all of the devices so they cannot communicate to each other. If you need devices to be able to talk to each other you may want to disable layer 2...
