Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I'm trying to troubleshoot some legacy devices. Is there a way to setup an SSID that is 2.4Ghz only? I've been playing with it for a bit and digging into the RF Profiles but I'm not making a ton of progress.
Serious question. I'm probably one of the largest Meraki fanboys here. But one thing that drives me crazy is the MX limitations on internet bandwidth. With larger pipes being available for much cheaper these days it is hard to swallow having to bu...
Hello Community,I've had a strange issue with one of my MV12's that I wanted to report here so some of you could check your environments. One of our MV12's is choppy when watching live. People will disappear because of the lag in the live view. Wh...
What are you trying to accomplish? In most setups the same LAN shares the two WANs load balanced. You can set an internet preference if something LAN side needs to stick to a certain LAN interface.
I only have MX64 and MX65 networks so I'm not sure. The number I provided is based off of this (see page 3) https://meraki.cisco.com/lib/pdf/meraki_whitepaper_mx_sizing_guide.pdfWhich is pretty accurate. You may get a little more bandwidth if you h...
MX67 only supports max throughput of 300M with all security enabled. The first device that can support 1G internet is the MX250 which is way to expensive for a small site. This is still painful for me to size at sites that have large pipes availabl...