Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Can i do the following on my2960 switch:Port1- public ip (address given from dhcp)- act as NAT-gateway for 2 vlan'sPort 2-12 vlan1Port 13-24 vlan2or do i need a router for this?
How can i best setup the following:Switch: 2960-24PC-SAP: AIR-AP1141NI have no Wireless Lan Controller.I want to setup 2 Vlan's on the 2960, 1vlan for wired pc's, and 1 vlan for the AP's. I will do dhcp on both vlans.I want to know how the best metho...
The thing i want to do is:vlan1: private (2 computers)vlan2: wlan, guests, 3ap'sAt first i didn't want a connection between these two. I was going to see if i could do the routing on the 2960s, or if i'd need an external router.But if i wanted to wri...
