Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello all.Does anybody has any idea on how to implement a backup solution for a wireless connection between an ethernet and an ATM interface?The senario is the following:An LMDS microwave system is used for the access part. The customer connects its ...
Hello GirishFirst i want to thank you for your suggestions.1)We indeed have a 1+1 redudancy in our Wireless network design but only in the BS side. The aproach to install equipment at the subscriber side in order to have full end-to-end redundancy is...
Try using a dynamic routing protocol for the bridge-link (such as rip, igrp, eigrp) runing exclusively over the ethernet interface (the serial interface must be in passive mode). Then configure static routes for the serial interface giving them bigge...
As a matter of fact when configuring channel groups for a E1 controller you can use the interfaces created only for standard leased line operation.If you want tou use isdn you sould configure pri-group for the E1 controller as long as isdn switch typ...
You sould try creating peer-groups wich will include only the parameters you want to be shared among all the naeighbors.e.g. router bgp 3500neighbor [name of the peer group] filter list [X] in/outneighbor xxx.xxx.xxx.xxx peer-group [name]Hope that he...
