Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Rather unusual question, but the customer cleaned up a bit too much, and threw away the mounting bracket for the MG41E. We need this to install it to an outside wall.I contacted Cisco support and our usual distributor for a replacement part. It does ...
I have dual MX86 with 2 IPs and a MG41 as back-up. MX are configured to use port 3 as backup WAN port.WAN1 is with fiber, has it's own fixed IP address for MX1. same for MX2. they have a virtual IP to share amongst them.WAN2 is with DSL, sitting behi...
I need advice on following scenario: full Meraki network. I have an SSID for Office users, one for Guest.I also have some IOT devices (warehouse scanners that only need to talk to a cloud service), but I don't want to create a separate SSID just for ...
I'm only learning about SmartPorts automation now. Tested a few things recently.Is it possible that when first manually setting a SmartPorts profile on a port, and then later using an automation to do this automatically on the whole switch, it is not...
The CPE of the main ISP only allows for a single uplink. So I had to go through a switch port to set this as there is a spare MX too.Setting failover mode to Immediate doesn't help at all, I tested that.
I guess I didn't take enough time. My bad for not reading the documents thoroughly enough.I do think up to 300 seconds is way too long to detect a soft failure, as compared to a hard failure.
I can see which Port Profile has been applied, that's not the problem. In fact, everything works.I only find it "logical" that when first applying a PortProfile manually, and then later applying one through an automation, and it would apply because o...
