Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have aironet 1250 and I want to generate a-msdu packets, but I failed.I used all combinations of following commands and iperf tool for generating packets.(1) a-mpdu enable: conf t -> dot11 addba enable -> dot11 addba timeout -> end -> sh run(2) a-m...
In general, every packet which was sent to/from an access point expects an acknowledge packet from the peer.But in 'no ack' mode, that acknowledge is not required. That means higher throughtput could be get if the air is clean.
