Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Dear All,We are using MX85 as firewall and down link is an Catalyst C4500 , our vlan routing is setup in MX85 .Now we find the traffic in the same vlan is up to 1Gbps as normal ,but the trafffic rate between Vlans is limited at 400Mbps . this rate is...
We have several CW9162 and CW9163 access points and we encountered unexpected high latency issue .Can you help us to know how to trouble shooting this issue ? Many APs encounted this issue ,sometimes it will be ok after i rebooted it. The latency to ...
In the past days ,our APs unexpected reboot (except the AP14 in red frame) , the reason is as below . I checked the log in switches ,only found port donw up event . These 4 APs are connected to 4 different Cisco 2960X switches. AP01 is CW9162 and o...
We want to route some specific ip addresses to a destination ,but i only found meraki can do this by whole VLan ? Is there a way to realize this requirement ?
Thanks ，it is the reason .When i disabled it ,the bandwidth goes up to 600 m. If i enable it ,whatever ruleset i choose ,the bandwidth goes down to round 300m. It is strange why this funnction will affect vlan traffic.
Yes ,I have opend a CASE and meraki confirmed this was caused by the firmware crash unfortunately they did not addressed the route cause for it therefor there is no solution now . I am sad for the ability for the meraki team.
I am sorry , I did not describe clearly .I want VPN user can access local netwrok meanwhile beside local network any other traffic route them to a dedicated line connect to LAN port 11 .
