While I have fixed many a rommon mode issues on sup engines (including the "remote command sw sh ver" confreg setting issue) I have a sup32 that just won't quit the rommon mode. The sup engine came from another switch and when I do a "set" I see it's...
Is it possible to upgrade IOS code on a remote router or switch over the network from your desk, without having to go to that location?If so, please provide the commands to do so. This is not your standard TFTP from the console connection.Thanks!
I have a client that sees and attaches to a 1242 AP but is unable to get an IP address from the DHCP server via the AP. It returns a msg. saying Limited or No Connectivity on the client. Does anybody know what may be going on? Is this an AP issue or ...
It gives a "error loading flash:imagename" error and goes to a default ap: prompt. The image on the system may be corrupt. How do I configure this ap to boot to another better image?Thanks!
I am getting mixed views from different vendors whether a Cisco 1242 AP can participate in an outdoor 1510 Mesh AP network using some sort of external antenna or something? I personally feel that it should be doable because both are Cisco devices. Or...
A slight modification to my approach. I just formatted the Cisco provided disk on a different sup engine, then copied the code I want to run on this failed sup engine, then attempted the whole thing again, and it's looking good so far. Phew...a small...
Thanks for the link but therein lies the problem. On doing a dir disk0: I get a "cannot open device disk0:" with an open error = -35. If I could access my flash card in disk0: I think I can recover the switch.I know the disk is good as I have used it...
Hi Gautam,While all the switches (Cisco or not) can pass traffic to each other for their respective VLAN's, to my knowledge you will require a Layer 3 device to pass data between VLANs, whether Cisco or otherwise. Hope this helps!
Thank you both for your replies. Rick, I found your response more accurate in terms of what I was looking for. Edison is correct if I'm sitting by the router doing the upgrade.So, to do a remote TFTP or FTP, I have to ensure correct routing etc? Woul...
Thanks for all your responses, but this issue is tied to only this one AP. Other APs on the same SSID network have no problems, clients attach to them and get IP addresses without any problems. DHCP Server info has not changed, besides clients attach...
