Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi I have been trying to configure a 837 for a while now and I'm finally nearly there. So far the tests run(SDM interface test) and pass on atm0(WAN connection to the internet) but not on ethernet0. I am guessing i need to link them somehow but since...
Hi,I have just started messing around with cisco routers and I have run into a few things I can not found answers for.Firstly:I can configure a router and save the config with 'copy running-config startup-config' but when I restart the router the con...
Sorry no luck. Ping from computer connected to router didn't work neither did the SDM connection test from ethernet0 but the connection test from ATM0 did work as usaual.Here is the output you asked for:Router#sh versionCisco IOS Software, C837 Softw...
Sorry about the wait, it's been hectic at work. I hooked up the lan cable and was able to communicate with the router but not able to connect to the internet. I have fiddled with the config a bit so I'll post the changes(differences are in bold):!Thi...
No luck sorryhere is what SDM is outputting:ethernet0:checking exit interface... Failed exit interfae found: Dialer0 exit interfae found: Dialer0Failure ReasonsTo test connectivity, SDM tries to ping the configured DNS servers. ...
wouter(config)#interface ethernet0wouter(config-if)#duplex half ^% Invalid input detected at '^' marker.wouter(config-if)#Can't seem to find any other commands for the duplex settings on the 800 series. Do you guys know what...
